VTR1000F 2001 and up wiring diagram

From home to home ?...

Started to look at the wiring harness a week or so ago. The wiring on this bike consists of two main wiring harnesses.  One connects to the stuff in the headlight shell as well as the front...

The fourth replacement wire had a bullet connector on the other end to interconnect with the rear harness. The replacement connector ia not identical to the original, but is compatible. This bullet...

Ok……wiring is definitely not my strong point……..I can tig weld two razor blades together, but can’t solder worth a shit, have always gone to the local hardware store for blister packs of crappy connec...

Couldn't resist a solo drive to Honfleur via Pont Audemer. Then a leisurely drive back along the back roads through the Vexin, as beautiful as ever....

I had previously refurbished the original wire harnesses on tjis bike by removing what was left of the woven loom and replacing it with an expandable braided sleeve material with heat shrink at the jo...

Revisiting and enjoying one of my favourite rides. The A3072 from Bickleigh to Crediton. #divvymanstravels...

Coils get their connections, and a branch runs up to the condensers....

(Pads have been pushed back to stop rust patches on the discs whilst stored over winter. Hence the block of wood behind the brake lever)....

Pesky balancer shaft seal replaced, breather hose swapped to an upgraded one with a valve in it and oil changed....