LighTech chain slack adjusters

I just cleaned the chain yesterday. I used WD-40 to remove all dirty grease and then I applied MOTUL chain lub...

The one thing I would change about this bike would be the chain drive. My Moto Guzzi Stelvio has a shaft drive, like BMW big bores, and this makes for a smoother ride less maintenance and is stronger...

Get em all done I guess....

Hi folks what is the best Product for your Chain for Lubrication. Been off the bikes for a while and it used to be Castol wax but not sure these days. Any advice would be great thanks....

Move the bike slowly so as to find the position where chain upper section is more tensioned. Set the motorcycle on the side stand. Measure chain tension at the centre of the lower section, with the...

Hello everyone! You and I continue to work on the Sandy project - a small scrambler based on the Yamaha YBR125 motorcycle....

Evening everyone! Just wanted to share something I just found out about the drivetrain. The chain sliders had uneven wear so I changed them and also bought new chain rings and chain... Some kms have...

Always a good feeling! Wish they stayed this pretty....

I used a little gasoline and some rags to scrub the grime off the drive chain. The chain is in great shape but I hate a dirty chain....

When I got to taking the rear wheel off, trying to loosen the nut did not loosen the nut. Checking the other side of the axle confirmed that it's just spinning the axle as a whole. It even started rot...

I've noticed a lot of bikes on the street without a chain guard, I myself have never contemplated taking it off and I assume it's for solely looks as the weight reduction would be minuscule.....

Trying this soon...

We have some more pictures from our #TagAlong small bike adventure guys! With broken bikes - the wee Honda spitting a chain on this leg of the ride and some truly amazing scenery, we were in for a ver...

We put the chain and rear sprocket on no issues but the front sprocket castle nut wouldn’t budge. We tried using a 27mm 12 point sockets and it spun after given a decent amount of torque even though t...