Front wheel is done. New bearings, Avon 65, and rotors.Goes just as fast as you can push her!...

Got the rear suspension and new rear tire on her...

White Super Fine rouge and Zephyr Pro 40...

This should be hours of pure bliss....

Rear wheel as good as I can get to polish out. The cast aluminum on the spokes and hub are real pain!...

A lot of maintenance to do including fork seals. Going to be lengthy project! But it's worth every single spare minute....

This will make you ill! I don't think sloshing a little bit of fresh petro is going to do any good. If my leg was long enough I'd kick my own ass, That's 8 years worth....

Christmas 2016, I gave myself a project to rebuild the gearbox of my broken engine and put it back into this bike, original engine back in so to speak....

After the accident the right front brake disc was slightly bent of about 4-5 mm inside. I thought, that I would be able to fix it at home and without using any special tools....

Last step before the morning's ride!...

In every fitting of a new tire, always checking for a straight wheel, good working bearings and a balancing at the end....

Coming soon on youtube....

A photo taken while I was exiting from turn one in Achna Racing Speedway...

Just a quick ride before work...

Today my Connie turned 10 years old. It has been an astounding bike and nothing but reliable. It eats miles for breakfast and can run with the fast guys too....

With the number of bikes, and highly likely move to Cali, I traded the Ninja 650 for a 1994 Mazda Miata MX-5. I bought the 650 about 3ish years ago at 15k miles, and put 16k miles on it, so I got my m...

After a spill in deep gravel, my cycle pirates shifter finally was about to give up completely. Thankfully a week prior I'd ordered a set of fully adjustable, racing rearsets that matched the special ...