I have a replacement but am unsure of how to get the broken one out and am scared to cause any damage to threading or something....

Replacing the fork seals on my bike and I can't get the shaft to come out. I've put the forks in a clamp and violently pulled to no avail. The other one came apart just fine. Any ideas? 08' CBR 600RR...

So I went into my bike to fix a c28 f1 code on a gsxr 750 and I found these two not connected to anything and I have no clue what they are I've asked friends if they have an idea and they don't either...

I just changed the clutch it was my first time 4th gear is still slipping it stay but once you add throttle, it drops back down to three before the clutch change it didn't even recognize 4 I would hav...

What connector connects to the kick stand sensor. I sent mine to a shop and it came back without the sensor. Just need a little guidance on with connector is used for it so I can just bypass it....

Recently started noticing in 2nd gear and 3rd gear at higher rpms get vibrations through my foot pegs and seat. I'm not sure If this has always been there or not, just had a new rear tire put on at a...

I'm changing out my chain and sprockets to a 520 conversion but I'm not sure which way the front sprocket faces. How can I measure which way it faces with one side having a shoulder and not the other?...

Replaced the lower cowls a few weeks ago and they were stained w this greenish corrosion looking stuff. Checked the under the bike today and noticed it again. Coolant leak?...

So I replaced my shift shaft seal and put everything back the right way, aligned the shifter with the marking on the shift rod. However I may have pushed the shift rod into the engine (possibly) Also...

Not a little.. I mean a lot of it. What's the issue?...

Turned bike off and on then it worked fine. I was doing a small pull, probably in 2nd gear at 9k rpms on my CBR 600RR when my check engine light came on and I was rapidly decelerating. I pulled off to...

Any ideas what could cause the dash light to flash like normal but the indicators themselves (front and rear) not to work? Seems my indicators work on one side only which I think rules out an issue wi...

When I got to taking the rear wheel off, trying to loosen the nut did not loosen the nut. Checking the other side of the axle confirmed that it's just spinning the axle as a whole. It even started rot...

My zx6r has been leaking from the left side and has had this build up for awhile, i was looking to see if anyone can help diagnose the issue?...

I flushed my coolant last night and there was oil in it, also it was very milky. So then I decided to just change my oil to make sure there wasn't any coolant in it and there indeed was not coolant in...

Does this spark plug look burnt out or is this a normal look for one that's done a few thousand miles?...