Yesterday my dad drove me to his friend nate's shop. Nate is the guy we will have paint my fenders and gas tank. We left the tank and fenders with him to sand blast and my dad will pick them up from h...

Concerned it would be too easy to damage the frame. I cut into the lower inner race with a Dremel, cracked it with a small cold chisel and used it to drive the new one on. There was no problem using...

The first thing changed consumables and installed \ filled the following: 1.Oil filter Hiflofiltro HF191; 2.Battery VARTA Powersports AGM; 3.Motorbike 4T 10W40 Street Synthetic Oil....

Guess who dropped their special ultra light weight pressed metal brake leaver pivot nut down inside the fairing today ? I shall see what Mr Bembo wants for a replacement, and the nut may still be ther...

I have been umming and erring on whether I should do this or not. The only KTM dealer who I trust to do this just quoted me between £800-£1000 (about 950-1150 euros) so I have decided to take the matt...

It's nice to ride from the ocean to the snow...

It took me a long time to buy this bike, and I never thought I would buy a Golda. At different ages there were different reasons why not - starting from the old age of the oppositions and ending it on...

Hello everyone, quick question: Can these Brake pads still be used? Bike is a Honda CBR 600RR and these are from the back brake calliper. just did new ones in the front (all 4 of them). Do these also...

It took me on a tour of Europe that summer and fall from England to Istanbul, and back to Northern Germany, where I put it on a ship back to the states. A few weeks later, I picked it up in New Jerse...

My view at the MotoGP. This clip is from the "Sprint"....

What a great trip I had. Another adventure doing the MCGTTX hitting the (scavenger hunt) destinations and wrapping up the last three days at the MotoGP near Austin. First day out I was caught in a 30...

The folks at Rebel Gears delivered big time on service, knowledge, and product! I received my 56 tooth overlay sprocket today....

You need 12 off 17mm x 6mm Dzus fasteners and 12 slip on clips. D8 are the better machined fasteners. Available in crosshead , allen hex or D tab for hand removal. 3 along the top of the mi...

So I noticed this small nail in my rear tyre after went over a pothole and wanted to check my rims. The nail is about the same size as those Ikea nails you use to nail in your backboard. I posted a ke...

I have leftover motul 3000 4t mineral oil from my first oil change but bought synthetic oil from kimpex 4t 10w40. Since have it, why not use it?...

The piston I ordered is technically a piston for a BSA, however, it will work for my bike perfectly. I needed a +.020 piston (20 over the original production size piston) because as the piston goes up...

The bigger the bore, the softer the engagement. It should improve the function a lot....

Does anyone have an idea to which model it could belong to?...

1. Detailing... engine, chain, sprockets and guards, rims, wax the painted parts 2. Swap the pillion pegs back to the original solo rearsets 3. Fix the seat hinge with its busted stud 4. Lube and a...